If this home position sensor is defective, this will cause problems. Reverse feeding several pages at a time may cause a paper jam. One certain Epsons, this sensor was a switch, and this would become erratic. Then close the paper guide cover. The following table shows the options available for each printer setting.
I was creating the papersize properly. Removing continuous paper with labels. If you would like to register as an Epson partner, please click. The printer will function with the printer cover open or removed, but for maximum safety keep the cover closed. Because thick paper requires a straight paper path to avoid paper jams, you should load paper in the front or bottom slot when using the pull tractor.
Tear off the printed document using the tear-off edge of the paper tension unit. Positioning the continuous paper supply Before using continuous paper, make sure you line up your paper supply with the tractor feeder as shown below, so that the paper feeds smoothly into the printer. Make sure your paper has a clean, straight edge. Note: If your paper's perforation is not properly aligned with the tear-off edge, you can adjust the tear-off position using the Micro Adjust function as described in. Flashes when paper has not been fully ejected or paper is jammed. Removing the tractor from the front push position Follow these steps to remove the tractor from the front push position: Make sure the printer is turned off. If the message that indicates the paper jam does not disappear even after removing the jammed paper following the procedure, there is a possibility that torn pieces of paper are still left inside the printer.
Then slide the right sprocket to match the width of your paper, but do not lock it. Hold down the Pause button for three seconds. Then press the Font button until the three Font lights indicate the desired font. If the first line on your page appears too high or low, you can change its position by using the Micro Adjust function as described in. You can unsubscribe at any time with a click on the link provided in every Epson newsletter. Make sure the printer is turned off.
Store the paper tension unit in a safe place. Make sure the printer is on and paper is loaded. Press the Pitch button until the three Pitch lights indicate the desired pitch. If necessary, lift the printer cover so you can see the paper position. Release the sprockets by pulling the sprocket lock levers forward.
Change the Font and Pitch buttons to a font of Courier and a pitch of 10. If it is, press the Pause button to stop printing. Create a new discussion If you're asking for technical help, please be sure to include all your system info, including operating system, model number, and any other specifics related to the problem. . See How to download drivers and software from the Epson website for more information. Then slide the right sprocket to match the width of your paper, but do not lock it.
The printer will function with the printer cover open or removed, but for maximum safety keep the cover closed. Note: For your safety, Epson recommends operating the printer with the printer cover closed. Lift the printer cover and pull it straight up and off the printer. Set the paper release lever to the front push tractor position. Using the tractor in the rear push position The tractor is installed in the rear push position when the printer is shipped. Also set the paper-thickness lever located under the printer cover to the proper position for your paper's thickness.
Epson is not responsible for any use of this information as applied to other printers. When the printer receives data, it automatically loads the paper and starts printing. After you finish printing, tear off the printed document at the perforation nearest the paper exit slot. When auto tear-off is on, the printer automatically advances the paper to the tear-off position whenever it receives a full page of data or a form feed command followed by no more data. It also includes a Type-B optional interface slot in case your computer requires a different type of printer interface. If your printing appears too high or low on the page, you can use the Micro Adjust function to adjust the top-of-formposition, as described below.
If necessary, lift the printer cover so you can see the paper position. Expected to ship within two weeks. Feeds continuous paper backward to the standby position if a sheet is loaded. Attach the paper guide and lay it flat on the printer and slide the edge guides to the middle of the paper guide. Load one sheet of paper into the printer. Make sure the tractor is installed in the front push position.